Professional Air Pick Pneumatic Breaker Air Chipping Hammer Jackhammer

Professional Air Pick Pneumatic Breaker Air Chipping Hammer Jackhammer

Routine maintenance

1. The normal working pressure of the gas is 0.5MPa. When working normally, add lubricating oil every 2h. When filling the oil, first remove the air pipe joint, tilt the air raft, press the shank, and inject it from the joint pipe.

2. During the use of the gas cylinder, disassemble it at least twice a week, clean it with clean kerosene, blow it dry, apply oil, and assemble it. When parts are found to be worn and out of order, they should be replaced in time, and it is forbidden to work with gas.

3. When the cumulative use time of the gas is above 8h, the gas is cleaned.

4, when the gas is idle for more than one week, it is necessary to oil the gas.

5. Polish the bristles in time.

Machine maintenance

1. The spare gas in the removal process shall not be less than 3, and the number of gas to be repaired shall not exceed 3;

2, the inspection and maintenance of the wind repair time is not more than 2 days;

3. The grinding interval of the brazing filler metal in use is not more than 15 days;

4. When the wind is scrapped, the average life expectancy is not less than 100t titanium sponge per piece;

5, broken brazing, the tail of the shank should be recycled, and the brazing hole is polished in time;

6. Retire the unusable winds, recycle the usable parts, and stack the scraps.

Operating procedure

First, precautions before work:

1. Check the safety of the work surface and make a knock on the top.

2. Check the air volume and blow off the dirt inside the rubber duct.

3. Check if the hose joint filter and the fixed steel sleeve of the wind head are clean.

4. Check if the end of the pneumatic pick and the steel sleeve are skewed and whether the gap is suitable.

5. Wipe the air squeegee tail first, then insert it into the air shovel and fix it with a spring.

Second, matters needing attention during work:

1. When the wind continues to be used, it is necessary to refuel at any time. When refueling, it will be poured into the plastic pipe, and the wind will fall or crush the wind and hurt people.

2. The air pipe joint and the connecting pipe should be loosened at any time, and should be tightened in time. The high-voltage straight-through must be clamped with a U-shaped clamp. The wire cannot be replaced by a wire with a U-shaped clamp.

3, keep the air duct intact, do not make the air duct curl, the meteorite and other objects are damaged and cause air leakage.

4. It should be avoided that the wind brazing is stuck by the rock. When the wind brazing is inserted into the rock depth, it must be under the windy spring to prevent the use of the wind and the edge of the rock.

5. When the wind fails, it shall be sent to the machine for repair or replacement in time, and shall not be opened and dismantled at the work place.

Main Features

It is widely used in road construction, concrete and other hard objects demolition.

It is featured by durable parts, good performance and easier operation,
which is a classic products among breaking tools.
Crashing in concrete and clay
Destorying hard rock
Blasting for railway construction ,
water conservancy construction and
defence project facility.

Contact us if you need more details on Professional Air Pick. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Professional Air Pick Pneumatic Breaker、Air Chipping Hammer Jackhammer. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Rock Drill > Pneumatic Rock Drill